Различия

Показаны различия между двумя версиями страницы.

--- конфигурирование [2019/02/17 15:02]
admin
+++ конфигурирование [2020/07/26 15:25]
178.124.187.175
@@ Строка 26: / Строка 26: @@
 * load - load config from NVRAM
 * kill - test watchdog timer (normally, causes reboot)
+CLI commands must be send via serial port with 115200 baud rate / 8N1 params: 8 data bits, no parity bit, 1 stop bit.
+Example via shell:
+```
+> stty -f /dev/cu.usbmodem146101 ispeed 115200 ospeed 115200 -parenb cs8 cstopb
+> echo "ip" > /dev/cu.usbmodem146101
+> cat /dev/cu.usbmodem146101
+```
+Same can be done via GUI e.g. from Arduino IDE (serial monitor). Serial port must be configured (MacOSX config file ~/Library/Arduino15/preferences.txt)
+```
+serial.databits=8
+serial.stopbits=1
+serial.parity=N
+serial.debug_rate=115200
+serial.line_ending=1
+```
 The example of config files you can find in config folder

LightHub